David Dyer-Bennet
Patron
- Joined
- Jul 13, 2013
- Messages
- 286
I just upgraded to 9.10.1 today. And then I added a new jail. I don't know if this behavior appeared in the update I installed; I have one exiting jail that did not show this behavior.
Using the simple interface, I specify just a jail name. When I then open a shell in that jail and run ifconfig, I see this (no IPv4 address shown):
Note the MTU is 1500, and that this is an ifconfig from within the jail, not the often-discussed issue that jls doesn't list IP addresses even though the man page claims it does. So I don't believe I'm seeing either of the common problems associated with this symptom.
If I then edit the jail, the IPv4 networking boxes are not filled in, including the DHCP checkbox not being checked. Furthermore, although it doesn't look grayed out, I cannot check the DHCP checkbox.
In the Jail Configuration GUI screen, both IPv4 DHCP and IPv6 AUTOCONFIGURE are checked.
If I create another new jail in advanced mode, I'm still not able to check the IPv4 DHCP checkbox in the GUI.
Any ideas?
Using the simple interface, I specify just a jail name. When I then open a shell in that jail and run ifconfig, I see this (no IPv4 address shown):
root@pub:/ # ifconfig
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6>
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1
inet 127.0.0.1 netmask 0xff000000
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
epair1b: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=8<VLAN_MTU>
ether 3e:20:4d:3f:84:f4
inet6 fe80::3c20:4dff:fe3f:84f4%epair1b prefixlen 64 scopeid 0x2
nd6 options=23<PERFORMNUD,ACCEPT_RTADV,AUTO_LINKLOCAL>
media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>)
status: active
root@pub:/ #
Note the MTU is 1500, and that this is an ifconfig from within the jail, not the often-discussed issue that jls doesn't list IP addresses even though the man page claims it does. So I don't believe I'm seeing either of the common problems associated with this symptom.
If I then edit the jail, the IPv4 networking boxes are not filled in, including the DHCP checkbox not being checked. Furthermore, although it doesn't look grayed out, I cannot check the DHCP checkbox.
In the Jail Configuration GUI screen, both IPv4 DHCP and IPv6 AUTOCONFIGURE are checked.
If I create another new jail in advanced mode, I'm still not able to check the IPv4 DHCP checkbox in the GUI.
Any ideas?