Simplicity
Dabbler
- Joined
- Jun 13, 2015
- Messages
- 28
Hi All,
UPDATE: Got my jails to work outside of the GUI by editing the rc.conf file and setting enable = YES ie. sickrage_enable="YES" . The plugins work on the IP i set and all my config is working on the SSD. Not sure how to get FreeNAS updated to v9.10 and same issue, was hoping it would have fixed the issue. Plugins are running but not found in the FreeNAS gui. When I install the plugin again it detects an existing one and increments the name by +1 like transmission_2..... I have rebooted the jails and FreeNAS many times.
I followed these steps and successfully migrated the jails to the SSD, but all my plugins are missing in the GUI.
Steps I used were: *taken from this forum*
Steps:
Turn off all plugins (Plugins->Installed)
Stop all jails (Jails->View Jails)
Run these commands via CLI:
Change the Jail Root to /mnt/ssd_pool/jails (Jails->Configuration)
Start jails/plugins
Check that everything works and destroy the original jails dataset (main_pool/jails)
Essentially I followed the above steps to the dot. I thought everything was working so I deleted my main_pool/jail. If i try to install new plugins it detects the name already exists and increases the count i.e plexserver_2 is now installed, but my _1 is not showing even though the jail is running.
UPDATE: Got my jails to work outside of the GUI by editing the rc.conf file and setting enable = YES ie. sickrage_enable="YES" . The plugins work on the IP i set and all my config is working on the SSD. Not sure how to get FreeNAS updated to v9.10 and same issue, was hoping it would have fixed the issue. Plugins are running but not found in the FreeNAS gui. When I install the plugin again it detects an existing one and increments the name by +1 like transmission_2..... I have rebooted the jails and FreeNAS many times.
I followed these steps and successfully migrated the jails to the SSD, but all my plugins are missing in the GUI.
Steps I used were: *taken from this forum*
Steps:
Turn off all plugins (Plugins->Installed)
Stop all jails (Jails->View Jails)
Run these commands via CLI:
Code:
zfs snapshot -r main_pool/jails@relocate zfs send -R main_pool/jails@relocate | zfs receive -v ssd_pool/jails zfs get -rH -o name -s received mountpoint ssd_pool/jails | xargs -I {} sh -c "zfs set mountpoint=/{} {}; zfs mount {};"
Change the Jail Root to /mnt/ssd_pool/jails (Jails->Configuration)
Start jails/plugins
Check that everything works and destroy the original jails dataset (main_pool/jails)
Essentially I followed the above steps to the dot. I thought everything was working so I deleted my main_pool/jail. If i try to install new plugins it detects the name already exists and increases the count i.e plexserver_2 is now installed, but my _1 is not showing even though the jail is running.
Last edited by a moderator: