Hello!
I'm use FreeNAS 9.2.1.7 x32
Gigabit Ethernet D-link DGE-528T
Intel Pentium IV 3.0 GHz
RAM 1024 GB ( 2 x 512 )
Data HDD: ST31000340AS ( 1.0 TB ) SATA
System HDD: WD400JB (40 GB) IDE
When I start to download a large file (about few gigabytes), the speed reaches 40-60 MB s, but a few minutes later drops sharply to almost zero (about 50-100 kB/s). And does not return to previous values until the system reboots.
I have this problem on FTP and CIFS (SMB)..
1000 MB LED indicator on ethernet card is flashing
CPU Load < 5%
Free RAM > 300 MB
SWAP Utilization: 0.0
SMART on HDDs is good (check in Victoria)
Of course, I tried to configure built in motherboard 100 MB network card, but still have this problem.
What's the problem?
I'm use FreeNAS 9.2.1.7 x32
Gigabit Ethernet D-link DGE-528T
Intel Pentium IV 3.0 GHz
RAM 1024 GB ( 2 x 512 )
Data HDD: ST31000340AS ( 1.0 TB ) SATA
System HDD: WD400JB (40 GB) IDE
When I start to download a large file (about few gigabytes), the speed reaches 40-60 MB s, but a few minutes later drops sharply to almost zero (about 50-100 kB/s). And does not return to previous values until the system reboots.
I have this problem on FTP and CIFS (SMB)..
1000 MB LED indicator on ethernet card is flashing
CPU Load < 5%
Free RAM > 300 MB
SWAP Utilization: 0.0
SMART on HDDs is good (check in Victoria)
Of course, I tried to configure built in motherboard 100 MB network card, but still have this problem.
What's the problem?