AtlThundrDan
Cadet
- Joined
- May 13, 2013
- Messages
- 2
Hello all!
I have an iXsystems built FreeNAS device with dual 10GbE adapters for a total of 4 ports. I have two core Cisco 5548 switches with two cables going to each.
My goal is to have LACP or a similar high performing protocol to do load balancing on each.
I've got it all set up as best as I knew, and looks like it's working on the switch side, but I get no ping or connectivity.
Outside of this, as you can tell this is for an enterprise and I wanted to see if anyone else had thoughts or done some similar that worked well with NX-OS.
I have gotten this to work with round-robin over two ports, but that was it and it seemed slow. Yes, 40GB is high.... too high in fact, but it gives me full redundancy.
Thanks in advance.
I have an iXsystems built FreeNAS device with dual 10GbE adapters for a total of 4 ports. I have two core Cisco 5548 switches with two cables going to each.
My goal is to have LACP or a similar high performing protocol to do load balancing on each.
I've got it all set up as best as I knew, and looks like it's working on the switch side, but I get no ping or connectivity.
Outside of this, as you can tell this is for an enterprise and I wanted to see if anyone else had thoughts or done some similar that worked well with NX-OS.
I have gotten this to work with round-robin over two ports, but that was it and it seemed slow. Yes, 40GB is high.... too high in fact, but it gives me full redundancy.
Thanks in advance.
