thedeadzone
Dabbler
- Joined
- Feb 13, 2014
- Messages
- 20
Hey there,
So since its seems that ipv6 is should now work in Jails, i tried to set it up so that I can reach my jails from the outside.
I already can reach every service and the web gui via the ipv6 Address of freenas, so this is properly configured.
My problem now is to get the interface inside the jails take a ipv6 address.
I tried setting the interface to
I added the information to the configuration tab of the jails page:
Output of ifconfig shows the following :
Did someone already get it to work or can point me in the right direction to get ipv6 working in the freenas jails.
So since its seems that ipv6 is should now work in Jails, i tried to set it up so that I can reach my jails from the outside.
I already can reach every service and the web gui via the ipv6 Address of freenas, so this is properly configured.
My problem now is to get the interface inside the jails take a ipv6 address.
I tried setting the interface to
- No Vimage
- Vimage
- Vimage + Nat
I added the information to the configuration tab of the jails page:
Code:
Ipv6-Network: 2a02:908:d012:e000::/57 IPv6 Network Start Address: 2a02:908:d012:e000::/57 IPv6 Network End Address: 2a02:908:d012:e07f:ffff:ffff:ffff:ffff/57
Output of ifconfig shows the following :
Code:
root@plexmediaserver_1:/ # ifconfig lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384 options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6> inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1 inet 127.0.0.1 netmask 0xff000000 nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> epair1b: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 9000 options=8<VLAN_MTU> ether 02:47:5c:00:0e:0b inet 192.168.178.22 netmask 0xffffff00 broadcast 192.168.178.255 nd6 options=1<PERFORMNUD> media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>) status: active
Did someone already get it to work or can point me in the right direction to get ipv6 working in the freenas jails.