mattragusa
Cadet
- Joined
- Oct 28, 2018
- Messages
- 8
I had a hard drive failure, which led to the hot spare kicking in.
Following the initial resilver, I replaced the bad drive and let this new drive resilver. In the past, once this was complete, the hot spare would return to its stand-by state.
This time, it still shows as in use both in the GUI and the shell. I can't find anything about this peculiar situation in the forums.
How do I release the hot spare manually?
Much appreciated
Following the initial resilver, I replaced the bad drive and let this new drive resilver. In the past, once this was complete, the hot spare would return to its stand-by state.
This time, it still shows as in use both in the GUI and the shell. I can't find anything about this peculiar situation in the forums.
How do I release the hot spare manually?
Much appreciated