I have set up my freenas system and when i map a drive in windows to freenas the volume appears as 828k ? not sure where or what i have done wrong / missed ?
Hardware is as follows
rioworks hdama motherboard
2 opteron 275 proccessors
8 gig ecc ram
AMCC 3com 9500S-4LP raid card fitted 257 mb ram
4 western digital red 1TB drives
FREENAS 9.1.1. installed onto 8Gig Compact flash card fitted to ide - compact flash holder
drives are setup as raid 10 on 3com card so available space 1.8 TB
Mounted the drive - ada0 as Ext2
within freenas i have created a volume on disk ada0 named Drive - 1
i had to enter the command /mnt/Drive - 1 as it didn't appear in browse box as the instructions suggested ?
all permissions where ticked in the check boxes
Then i created a CIFS folder named share
Bit lost now
Any help advise please
steve
Hardware is as follows
rioworks hdama motherboard
2 opteron 275 proccessors
8 gig ecc ram
AMCC 3com 9500S-4LP raid card fitted 257 mb ram
4 western digital red 1TB drives
FREENAS 9.1.1. installed onto 8Gig Compact flash card fitted to ide - compact flash holder
drives are setup as raid 10 on 3com card so available space 1.8 TB
Mounted the drive - ada0 as Ext2
within freenas i have created a volume on disk ada0 named Drive - 1
i had to enter the command /mnt/Drive - 1 as it didn't appear in browse box as the instructions suggested ?
all permissions where ticked in the check boxes
Then i created a CIFS folder named share
Bit lost now
Any help advise please
steve