Good day!
I have two FreeNAS servers of the same hardware and software configuration (FreeNAS-11.3-U3.1)
There is a LUN on each FreeNAS, it is shared by isсsi in the ESHi 6.7 cluster.
I start the migration from one LUN to another LUN, and the migration traffic goes through the ESXi server, however, it is stated that FreeNas supports VAAI and migration traffic seems to go directly between storages, tell me why this may not happen?
The Enable TPK checkbox in the properties of both LUNs is worth it.
The fact that traffic goes through the ESHi server I see from the graphs of the network interfaces (I run into gigabits (network cards for the ESXi are gigabit)), and the network cards for the storages are 10 gigabits.
vCenter admin panel shows hardware acceleration is supported in the both storages.
Thanks for help.
I have two FreeNAS servers of the same hardware and software configuration (FreeNAS-11.3-U3.1)
There is a LUN on each FreeNAS, it is shared by isсsi in the ESHi 6.7 cluster.
I start the migration from one LUN to another LUN, and the migration traffic goes through the ESXi server, however, it is stated that FreeNas supports VAAI and migration traffic seems to go directly between storages, tell me why this may not happen?
The Enable TPK checkbox in the properties of both LUNs is worth it.
The fact that traffic goes through the ESHi server I see from the graphs of the network interfaces (I run into gigabits (network cards for the ESXi are gigabit)), and the network cards for the storages are 10 gigabits.
vCenter admin panel shows hardware acceleration is supported in the both storages.
Thanks for help.