SnoppyFloppy
Explorer
- Joined
- Jun 17, 2021
- Messages
- 77
Hi
I screwed up when I first set up my network bridge as I assigned my entire LAN subnet to the bridge (192.168.24.4:24 instead of /32) and now it gives me trouble as I want to setup my servers second NIC and pass it through to a VM.
When I try to assign IP 192.168.24.8/32 to second NIC it errors out which makes sense given that I try to assign an IP in the range that is already assigned to the first NIC.
Now my problem is that I can't change the subnet of the bridge interface to /32 (through the GUI) as it just keeps timing out.
I've also tried to delete the bridge + assign the correct IP/subnet to the first NIC and then test, but that also times out.
Any suggestions?
EDIT: I also tried through CLI but got an error message. I can't paste it right now but will do later.
I screwed up when I first set up my network bridge as I assigned my entire LAN subnet to the bridge (192.168.24.4:24 instead of /32) and now it gives me trouble as I want to setup my servers second NIC and pass it through to a VM.
When I try to assign IP 192.168.24.8/32 to second NIC it errors out which makes sense given that I try to assign an IP in the range that is already assigned to the first NIC.
Now my problem is that I can't change the subnet of the bridge interface to /32 (through the GUI) as it just keeps timing out.
I've also tried to delete the bridge + assign the correct IP/subnet to the first NIC and then test, but that also times out.
Any suggestions?
EDIT: I also tried through CLI but got an error message. I can't paste it right now but will do later.
Last edited:
