CAM status: SCSI Status Error

[aufalien]

Hi all,

Curious, I just installed v9.2.1.1, no drives in the system and my USB which has the FreeNAS OS is giving me these errors;

Feb 26 18:04:30 freenas kernel: (da1:umass-sim1:1:0:0): PREVENT ALLOW MEDIUM REMOVAL. CDB: 1e 00 00 00 01 00
Feb 26 18:04:30 freenas kernel: (da1:umass-sim1:1:0:0): CAM status: SCSI Status Error
Feb 26 18:04:30 freenas kernel: (da1:umass-sim1:1:0:0): SCSI status: Check Condition
Feb 26 18:04:30 freenas kernel: (da1:umass-sim1:1:0:0): SCSI sense: NOT READY asc:3a,0 (Medium not present)
Feb 26 18:04:30 freenas kernel: (da1:umass-sim1:1:0:0): Error 6, Unretryable error
Feb 26 18:04:30 freenas kernel: (da2:umass-sim1:1:0:1): PREVENT ALLOW MEDIUM REMOVAL. CDB: 1e 20 00 00 01 00
Feb 26 18:04:30 freenas kernel: (da2:umass-sim1:1:0:1): CAM status: SCSI Status Error
Feb 26 18:04:30 freenas kernel: (da2:umass-sim1:1:0:1): SCSI status: Check Condition
Feb 26 18:04:30 freenas kernel: (da2:umass-sim1:1:0:1): SCSI sense: NOT READY asc:3a,0 (Medium not present)
Feb 26 18:04:30 freenas kernel: (da2:umass-sim1:1:0:1): Error 6, Unretryable error

Can some one enlighten me? I've tried a few USB sticks as well as flash memory connected to a SATA port.

 

[aufalien]

FIXED in latest 9.2.1.2.

 

[Ben Evans]

OK This is weird, I'm getting this exact thing on my system now. It was working just fine, then the machine started acting slow, so I rebooted. On reboot it started doing this and wouldn't fully boot. I have 3 JBOD's attached to it, each with a pool, and one internal pool. After disconnecting all of the internal pools it booted, and I finally discovered that one pool would block booting entirely. One comes up fine, and the third comes up degraded because some of the drives aren't recognized. I've swapped cables, ports, swapped a new HD out for one that wasn't recognized (new HD wasn't recognized), and I'm at my wits end. I was guessing my HBA pooped out, but I couldn't figure how that would make 2 out of 3 arrays bork, but work fine with the third, and why it's consistently the same ones.
I know I'm resuscitating a long dead thread there, but those are exactly the messages I'm getting...

 

[Ericloewe]

I know I'm resuscitating a long dead thread there, but those are exactly the messages I'm getting...

Start a new thread and include the information that the forum rules ask you to include, particularly your hardware, of which we know nothing.