i have 2 x vlans enabled on an re0 interface. the re0 interface is attached to a switch that only allows tagged packets so re0 doesn't have an ip.
vlan 10 = 10.0.10.1/24
vlan 11 = 10.0.11.1/24
a windows dc exists on vlan 11 which freenas uses for active directory. even though freenas sucessfully starts active directory, it can't see any users. i suspect that is is down to the default gateway being the gateway for vlan 10.
i've set the default gateway & dns to the one on vlan 11 but still no joy. freenas boots and assumes the default gateway of vlan 10.
anyone got any ideas over this one?
vlan 10 = 10.0.10.1/24
vlan 11 = 10.0.11.1/24
a windows dc exists on vlan 11 which freenas uses for active directory. even though freenas sucessfully starts active directory, it can't see any users. i suspect that is is down to the default gateway being the gateway for vlan 10.
i've set the default gateway & dns to the one on vlan 11 but still no joy. freenas boots and assumes the default gateway of vlan 10.
anyone got any ideas over this one?