New FreeNAS user. Not sure if this should be posted as a bug or if known problem. Didn't see it mentioned in FAQ.
Using the IPMI web GUI interface of the Supermicro X11SSM-F, I get 3.7 volts reading on 3.3VCC. This is flagged as Red, "High Non-recoverable". Supermicro's first response was for me to upgrade the firmware (1.54) and reset to factory. While doing this, I noticed the voltage reading dropped to 3.55 Volts (green) during boot, but settled on 3.69 Volts (red) when boot complete. This was repeatable over a couple of reboots. I booted from a FreeDOS CD and the voltage reading is steady at 3.55 volts.
Could something in FreeNAS cause the voltage to exceed recommended value? Could FreeNAS be causing an incorrect reading over IPMI?
Using the IPMI web GUI interface of the Supermicro X11SSM-F, I get 3.7 volts reading on 3.3VCC. This is flagged as Red, "High Non-recoverable". Supermicro's first response was for me to upgrade the firmware (1.54) and reset to factory. While doing this, I noticed the voltage reading dropped to 3.55 Volts (green) during boot, but settled on 3.69 Volts (red) when boot complete. This was repeatable over a couple of reboots. I booted from a FreeDOS CD and the voltage reading is steady at 3.55 volts.
Could something in FreeNAS cause the voltage to exceed recommended value? Could FreeNAS be causing an incorrect reading over IPMI?