Setup Fibre Channel target on FreeNAS 8.2?

[RvdKraats]

Hi All,

As far as i can see FreeNAS supports my QLogic FC HBA, and i'd like to enable this card as a FC target and tie some file extends to it. Is there a way to tie an extend to this HBA (perhaps from the command line)? If iSCSI can present a target LUN, it should be possible with FC too...

Anyone have any experience with this?

Regards,

Rene.

 

[darinschmidt]

I too would like to know where i could find some information on this as i have several Qlogic cards that i would like to use.

 

[RvdKraats]

Hmmm...so, not much people use FC with FreeBSD/FreeNAS apparently :)
I found something about CTL (CAM Target Layer), which should make FC target mode possible. Anyone workd with this piece of software? Is it feasable to implement this in a FreeNAS box?