Hi guys,
I have a 68 disk apollo server, with an LSI 9207 card.
As not all drives showed up i purchased a LSI 9305 instead, and now I can see all the drives - but I see them double because of Multipath.
How do you guys handle MP in freenas?
Right now I'm at a very real risk of screwing my raid when replacing drives, as it doesn't show me only the active connection, but both.
So if I expand I could (and just did) expand with 2 connections to the same drive...
Also, trying to ferret out which drive is active in the new UI is pretty much impossible AFAIK.
And I made the dual raidZ2 before getting Multipath, so I haven't created it with the "Diskx" connections, but with the dax directly.
Any advice or help offered would be greatly appreciated.
I'm currently hosting ~100TB of backup storage on this and am expanding to around 300TB.
I have a 68 disk apollo server, with an LSI 9207 card.
As not all drives showed up i purchased a LSI 9305 instead, and now I can see all the drives - but I see them double because of Multipath.
How do you guys handle MP in freenas?
Right now I'm at a very real risk of screwing my raid when replacing drives, as it doesn't show me only the active connection, but both.
So if I expand I could (and just did) expand with 2 connections to the same drive...
Also, trying to ferret out which drive is active in the new UI is pretty much impossible AFAIK.
And I made the dual raidZ2 before getting Multipath, so I haven't created it with the "Diskx" connections, but with the dax directly.
Any advice or help offered would be greatly appreciated.
I'm currently hosting ~100TB of backup storage on this and am expanding to around 300TB.