Hi
I have a couple of Mellanox cards mostly Mellonox Connectx3,, I'm doing a migration so I had to setup a Mellanox Connectx-2 in a pinch. It's a two port card. When my machine boots up it says
Mellanox Connectx core driver v3.1
Initializing mtx4_core
Unable to determine PCI device Chain minimum bw
Unlocking Device
The web interface could not be accessed
Please Check Network Configuration
When I check the network Configuration it shows no ports available.
I'm using the second port so here is the command
To get around this select 9 shell command
sysctl sys.device.mlx4_core0.mlx4_port2=eth
I moved a lot of data to a new box with this card
So The card works fine with FreeNAS-11.3-U1.
But it would be nice to make this persistent......
I have a couple of Mellanox cards mostly Mellonox Connectx3,, I'm doing a migration so I had to setup a Mellanox Connectx-2 in a pinch. It's a two port card. When my machine boots up it says
Mellanox Connectx core driver v3.1
Initializing mtx4_core
Unable to determine PCI device Chain minimum bw
Unlocking Device
The web interface could not be accessed
Please Check Network Configuration
When I check the network Configuration it shows no ports available.
I'm using the second port so here is the command
To get around this select 9 shell command
sysctl sys.device.mlx4_core0.mlx4_port2=eth
I moved a lot of data to a new box with this card
So The card works fine with FreeNAS-11.3-U1.
But it would be nice to make this persistent......
Last edited: