fjose.galan
Cadet
- Joined
- Apr 7, 2020
- Messages
- 1
Hello, first of all I was searching in the forum and I did not seen anything related. I am totally new with freenas.
I built a system in my Proxmox server over a proliant Gen6 where I created a virtual machines for FreeNAS.
System preferences on Proxmox 5.4:
2 KVM Cores Xeon
8192 Mb of RAM
32GB Installation HDD
4TB Data HDD
vmware compatible NIC card
The installation is succesfull and I can reach the web ui on the DHCP assigned IP shown in the CLI when boot is finished (Main menu 1-11 options)
I log in in the web ui using the assigned root password and went to configure the network card to assign a static IP.
I set the static IP on the vtnet0 card editing the preferences and when apply the changes it shows a message regarding that those changes will be used during 60 seconds (time is configurable) and after that it will be recovered back unless you have selected KEEP PERMANENTLY...
For this that is my question, How to keep parameters permanently?
Regards
Frank Galan
I built a system in my Proxmox server over a proliant Gen6 where I created a virtual machines for FreeNAS.
System preferences on Proxmox 5.4:
2 KVM Cores Xeon
8192 Mb of RAM
32GB Installation HDD
4TB Data HDD
vmware compatible NIC card
The installation is succesfull and I can reach the web ui on the DHCP assigned IP shown in the CLI when boot is finished (Main menu 1-11 options)
I log in in the web ui using the assigned root password and went to configure the network card to assign a static IP.
I set the static IP on the vtnet0 card editing the preferences and when apply the changes it shows a message regarding that those changes will be used during 60 seconds (time is configurable) and after that it will be recovered back unless you have selected KEEP PERMANENTLY...
For this that is my question, How to keep parameters permanently?
Regards
Frank Galan
