- Joined
- Jul 2, 2019
- Messages
- 648
Background:
I have created a VLAN (numbered 101) for the 192.168.101.0/24 subnet on the pfSense router and within the Unifi Controller.
I have the Unifi switch port set to all VLANs. I have tried setting the switch port to only use
I created
The VLAN interface
I can confirm from the FreeNAS console that I can ping the pfSense VLAN gateway of 192.168.101.254
I created the jail with:
Basic Configuration
One other thing: I need to reboot the FreeNAS box (a real pain in the buttocks ;) as my ESXi hosts reside on an NFS mount) when I set up the VLAN as networking stops working outside of ssh to the FreeNAS box and the NFS network (on another, separate physical interface
Any help/suggestions appreciated and welcome!
Config below for mobile users:
- I have VLANs on my pfSense firewall - working fine
- I have my UniFi switch using the VLANs - working fine
I have created a VLAN (numbered 101) for the 192.168.101.0/24 subnet on the pfSense router and within the Unifi Controller.
I have the Unifi switch port set to all VLANs. I have tried setting the switch port to only use
VLAN101
as well.I created
VLAN101
on FreeNAS on an interface (igb3
) that was not otherwise used.The VLAN interface
igb3
is shown as up in the GUI.I can confirm from the FreeNAS console that I can ping the pfSense VLAN gateway of 192.168.101.254
I created the jail with:
Basic Configuration
- VNET - enabled
- Berkely Packet Filter - enabled
- IPv4 Interface - vnet0
- IPv4 Address - 192.168.101.1
- IPv4 Netmask - 24
- IPv4 Default Router - 192.168.101.254
- interfaces -
vnet0:bridge101
- vnet_default_interface -
vlan101
One other thing: I need to reboot the FreeNAS box (a real pain in the buttocks ;) as my ESXi hosts reside on an NFS mount) when I set up the VLAN as networking stops working outside of ssh to the FreeNAS box and the NFS network (on another, separate physical interface
igb1
; igb0
is the FreeNAS host interface in 192.168.20.0/24). The web page no longer is accessible. I tried restarting the network stack with /etc/rc.d/netif restart
but that did not seem to work and "broke" ssh connectivity.Any help/suggestions appreciated and welcome!
Config below for mobile users:
- Operating System: FreeNAS-11.2-U6
- Chassis: Supermicro SuperChassis 825TQ-R740LPB 2U 8 x 3.5" Drive Bays
- Power Supply: 2 x 740 Watt PWS-741P-1R Power Supply Platinum
- Backplane: Supermicro BPN-SAS-825TQ 8-port 2U TQ (W/ AMI 9072)
- Motherboard: Supermicro X9DR3-LN4F+
- CPU: 2 x Intel Xeon E5-2630 V1 Hex (6) Core 2.3GHz
- RAM: 32GB DDR3 ECC (8 x 4GB - DDR3 - REG)
- Storage Controller: LSI 9210-8i 6 GB/S
- Boot Pool: 2 x Kingston AS400 120 GB SSD Mirrored (using motherboard SATA 6 GB/s)
- Pool_1: 5 x WD Red 3 TB RAIDZ2
- 2 x MiniDLNA servers (seperate subnets) with shared content
- NFS server for VMware ESXi 6.0
- CIFS for Windows clients