I had a perfectly working install for one day, now I am not able to re-install.
First install went fine. I started putting FreeNAS through its paces, and the web UI started to run extremely slowly. Shut down. Upon reboot, I received an error message; I believe something to the affect that it couldn’t find the kernel.
Given I was just testing, no big deal, start from scratch. I get stuck in the same place every time, Fatal Trap 12, at the end it stops at t4_get_port_stats.
Removing the Chelsio NIC, I get no error.
I have three different Chelsio NICS, and I get the same error on all. Tried with a Mellanox instead. With the Mellanox, I get a can’t allocate enough memory error.
Not sure what to do.
Specs:
SuperMicro X11
Xeon Scalable Bronze
256GB RAM
6 NvME’s Installed
LSI 9300 x 2
I took out the HBA’s and tried two separate Chelsio 420’s, two separate Chelsio 440, a Chelsio T-580, and Mellanox ConnectX-3. Same results as above.
I purchased new flash drives. Tried USB2 and USB3. Tried installing to HDD, tried installing to SSD. Same result.
Set BiOS to failsafe, tweaked a few different things. I believe with only internal NIC, it did install and boot fine. But, I need more than just the internal NiC.
Suggestions?
First install went fine. I started putting FreeNAS through its paces, and the web UI started to run extremely slowly. Shut down. Upon reboot, I received an error message; I believe something to the affect that it couldn’t find the kernel.
Given I was just testing, no big deal, start from scratch. I get stuck in the same place every time, Fatal Trap 12, at the end it stops at t4_get_port_stats.
Removing the Chelsio NIC, I get no error.
I have three different Chelsio NICS, and I get the same error on all. Tried with a Mellanox instead. With the Mellanox, I get a can’t allocate enough memory error.
Not sure what to do.
Specs:
SuperMicro X11
Xeon Scalable Bronze
256GB RAM
6 NvME’s Installed
LSI 9300 x 2
I took out the HBA’s and tried two separate Chelsio 420’s, two separate Chelsio 440, a Chelsio T-580, and Mellanox ConnectX-3. Same results as above.
I purchased new flash drives. Tried USB2 and USB3. Tried installing to HDD, tried installing to SSD. Same result.
Set BiOS to failsafe, tweaked a few different things. I believe with only internal NIC, it did install and boot fine. But, I need more than just the internal NiC.
Suggestions?