TheBadFrag
Cadet
- Joined
- Sep 14, 2019
- Messages
- 6
Hi there!
I just did my first FreeNAS install.
I created a new pool a RAIDZ with 6x 10TB WD Reds.
Now I can hear all the disk clicking continuously and the used capacity of the pool is going up steadily.
...BUT I'm not doing anything there are no shares or anything enabled.
Before the creation of the pool all the disks were spinning in idle and after a while the heads went to park position just like they should do.
Funny thing is that Reporting tab shows that the disks are not active! ...but I can hear them working all the time right next to me.
What is going on?
I just did my first FreeNAS install.
I created a new pool a RAIDZ with 6x 10TB WD Reds.
Now I can hear all the disk clicking continuously and the used capacity of the pool is going up steadily.
...BUT I'm not doing anything there are no shares or anything enabled.
Before the creation of the pool all the disks were spinning in idle and after a while the heads went to park position just like they should do.
Funny thing is that Reporting tab shows that the disks are not active! ...but I can hear them working all the time right next to me.
What is going on?