Can't assign IPv6 addresses to existing jail setup

Status
Not open for further replies.

wijagels

Cadet
Joined
Sep 27, 2013
Messages
4
Hello FreeNAS forums, I have a slight problem. I recently setup an ipv6 /64 block for my home network. While I'm still elated by the wonders of IPv6, I would like to assign my various jails public IPv6 addresses. I successfully added IPv6 addressing to the main interface on my box. I tested it and it works fine, everything works great over IPv6 for the main meat of the box. I tried going into the jail configuration page, and I am only presented with options pertaining to IPv4! All the hardware is real, no virtual stuff going on here. The IPv6 addresses are assigned by the wonderful hurricane electric service, and I have everything routed through a pfsense router. The FreeNAS build is 9.1.1-RELEASE-x64 (a752d35). So I want to give my jails IPv6 addresses in some way, even if I have to work in the CLI.
Thanks in advance for any help!

0e6Fg0W.png
 

wijagels

Cadet
Joined
Sep 27, 2013
Messages
4
Does anybody know a command line workaround? I'm hunting for a jail config file.
 
Status
Not open for further replies.
Top