Peter Hood
Cadet
- Joined
- Jan 24, 2017
- Messages
- 2
I tried to setup a VM with the new GUI on FreeNAS-9.10-MASTER-201703080410.
Everything works perfect except that i cannot select a ZVol while setting up a DISK device for the VM.
The selection field is just empty.
Also if i select VirtIO in the Mode Field for the DISK device the selection will not be saved but AHCI Mode stays selected.
Another question regarding iohyve.
After i created a VM with the GUI im able to start and stop the VM via GUI but i cannot see the VM on the console
using the iohyve commands
(e.g.: iohyve list) shows that there is no VM present at all.?
Everything works perfect except that i cannot select a ZVol while setting up a DISK device for the VM.
The selection field is just empty.
Also if i select VirtIO in the Mode Field for the DISK device the selection will not be saved but AHCI Mode stays selected.
Another question regarding iohyve.
After i created a VM with the GUI im able to start and stop the VM via GUI but i cannot see the VM on the console
using the iohyve commands
(e.g.: iohyve list) shows that there is no VM present at all.?