lagg

  1. Chin-Fah HEOH

    Loose 10GbE port causes ATA error count

    I have recently installed a 300TB FreeNAS (11.2_U5). It is running on a 16-bay Supermicro and expanded to a 24-bay Supermicro JBOD via AOC-S3008L-L8E (which is basically an LSI 3008 HBA). The HDDs are Western Digital HGST 10TB (P/N: HUH721010ALE600) There are 2 x 10GbE RJ-45 ports on the...
  2. Spud

    Removing LAGG Interface

    HI, I currently have 4 NICs on my freenas box and 3 of those are configured as a lagg interface (192.168.10.254). I want to temporarily remove the lagg interface for reasons I won't go into. I am trying to configure the 4th NIC on a different subnet (192.168.20.254) so I can still access the...
  3. Snow

    Quick question about LAGG LACP Jail setup

    Is it Possible to use sysctls to set a mac address on a jails IP address when Vimage is disabled ? I ask because I switched to LAGG LACP. I have had great Performance gains but would like my macs to be set in stone. I looked for a list of sysctls commands but did not Find any related to this...
    • Snow
    • Thread
    • jail setup lacp lagg mac address
    • Replies: 2
    • Forum: Networking
  4. cronsloth

    IPMI not dependable with and LACP (LAG)

    I'm not entirely sure if this is a known issue or just me not knowing all the underpinnings of how IPMI functions. But Here is my issue if anyone has any insight. I have a SuperMicro Server w/IPMI: Product Name: X9DRL-3F/iF I also have 'LAGG' configured to port bond my two NIC's on the...
    • cronsloth
    • Thread
    • ipmi lagg supermicro troubleshooting
    • Replies: 2
    • Forum: Hardware
  5. hexley

    SOLVED Losing packets between LAGG and VLAN

    Hi, I would like to get networking working for a VM under FreeNAS 11.1-U2, starting with DHCP. So far I've used only the FreeNAS GUI to create the following setup: Router [DHCP server] Switch [DHCP relay > LACP trunk] FreeNAS [lagg0{igb0,igb1,igb2,igb3} > vlan74 > bridge1 > tap0] VM [eth0] It...
  6. VictorR

    SOLVED 11.1-U2 LAGG/LACP and NFS mount error

    I had LAGG/LACP and NFS shares working seamlessly on this NAS for >2.5 yrs. Then, a GUI update to 11.1 failed and had to a complete reinstall. Although, the ZFS volume survived intact(I think). Setting up LAGG/LACP via GUI wizard results in this popup error (1, 2) But, when I look at...
  7. Constantin

    LAGG improvement opportunity

    Good morning, I have a suggestion for the failover LAGG feature to address what I would consider a bug. Specifically, my 10GBe interface from iXsystems (i.e. private-labeled Chelsio 520) is currently not functioning after receiving/installing a replacement motherboard for the mini XL (AVR54...
  8. High Voltage

    SOLVED networking idiot trying to set up quad Ethernet lagg group on FreeNAS

    so, I'm not going to lie here, I'm a complete and utter idiot when it comes to networking, I can get windows running, I can get FreeNAS running, I can configure both systems, and I can even through tech support phone calls to dell and my firewall manufacturer (zyxel usg 50 on its own subnet) get...
  9. S

    9.10.2-U2 (e1497f2) - Update Changed LAGG Settings

    Subject says it all. Updated to 9.10.2-U2 and could no longer find server at its static address that had been set for the LAGG in network settings. Checked my ARP and DHCP tables on the router and found 2 IPs under the dedicated server subnet and was able to log-in and change settings back to...
  10. A

    Regarding Lacp - not working

    Hi there , I have set up a freenas box this week . There are 8 loan cards attached to it. I have configured cisco switch . But the scenario is, when I try real-time bench mark , I hardly can cross 1gbps. And when I have checked the report , it shows only nic 4 was transmitting and receiving...
Top